Powering Down The Projector; Projector Power States; Using The Control Display Panel (Cdp); Guidelines For Using The Cdp - Christie CP2000-M Setup Manual

2.3

POWERING DOWN THE PROJECTOR

NOTICE: Once the projector is powered down, the fans continue to run for approximately 15 minutes
to ensure the projector and lamp have sufficiently cooled, at which point the fans automatically shut-
off. To avoid thermal stress that can lead to premature lamp failure, never unplug the line cord while
the fans are running and never unplug to power down.
1. From the CDP, press
allows for fast lamp ON response, if needed.
2. At the CDP, press
a COOL DOWN mode where the fans and electronics remain ON for 15 minutes. After this cool
down period, the projector enters STANDBY mode, and all fans and most electronics power down.
3. If servicing or removing any projector cover, disconnect AC.

2.3.1 Projector Power States

Table 2.1 identifies what occurs when any of the CDPs Power and Lamp keys are selected during the
4 main power states. NOTES: 1) The green status LED flashes while the yellow LED is ON steady
during "Boot Delay". 2) Both green and yellow status LEDs flash during "Cool Down". 3) To ensure
activation of the CDP Power or Lamp keys, press firmly for 1/2 second.
Table 2.1 Projector Status when any CDP Lamp or Power Key Selected
Standby Power Mode
Power ON To full power ON (boot delay)
Power OFF No action
Lamp ON To power ON and lamp ON
(boot delay)
Lamp OFF No action
2.4

USING THE CONTROL DISPLAY PANEL (CDP)

In most cases, the CDP is the primary interface with the projector. For a general overview, refer to
(Optional) Mount the Control Display
2.10 Using the Web User

2.4.1 Guidelines for Using the CDP

• Press keys one-at-a time; there are no simultaneous key combinations required or allowed.
• Pause briefly between key presses to allow the projector to respond to the previous action.
• Hold the navigation keys for continuous adjustment or movement in 1 direction.
• If no key is pressed within 5 minutes while in a menu, the system returns to presentation level. If
editing text or entering a numerical value, the entry is also lost.
• Press E
once to cancel a selection or go back 1 level in the menu.
XIT
CP2000-M/MR Setup Guide
020-100205-03 Rev. 1 (05/09)
. In this state the projector is still in POWER ON mode, which
LAMP OFF
. The lamp powers OFF first, then the projector automatically enters
POWER OFF
Power ON / Lamp OFF
No action
Power OFF (immediately)
To lamp ON (immediately)
No action
Panel. For more complex setup and diagnostic controls, refer to
Interface.
Projector's Current State:
Power ON / Lamp ON
No action
To cool down mode, after
15 minutes goes into
STANDBY mode.
No action
Lamp OFF (immediately)
Section 2: Basic Operation
Cooling Down Mode
Once the projector has
cooled down it remains in full
power mode.
Once the projector has
cooled down it goes into
STANDBY mode.
To lamp ON (immediately)
No action
3.3
2-5