2: Installation & Setup; Projector Installation - Christie CP2000-M User Manual

2 Installation & Setup
This section explains how to install, connect and optimize the projector for delivery of superior image
quality. Illustrations are graphical representations only and are provided to enhance the understanding
of the written material.
2.1

Projector Installation

The following set of instructions explain how to install, connect and optimize the projector for smooth
operation. Before installing, it is important to fully understand all site requirements and characteristics.
in a restricted access location.
the projector acclimatizes to the operating environment before powering up for a
minimum of 3 hours after unpacking. Failure to ensure the projector has properly
acclimatized could damage projector electronics. This applies to the lamp as well. The
lamp will be damaged if it is powered ON when below room temperate. Lamps should
be stored between 25-65°C (77-149°F).
moved or when it has been levelled.
Ensure the following tools and components are on hand before beginning. NOTE: In general,
fasteners are metric sizes and require metric tools. However, to complete lamp installation imperial
tools are required, which are provided inside the rear access door of the projector.
 12" screwdrivers: Phillips® #2 (magnetic) and flat
 19mm and 7/8" wrenches
 Assorted Allen® keys (metric)
 Single-phase 20A connection of AC supply to accommodate N6-20P plug
 Protective clothing/safety gear (required when handling the lamp)
 Lens cleaning tissue and solution
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)
All installation procedures must be performed by a qualified technician
When transporting the projector from a cold environment it is essential
Auto LampLOC™ must be run any time the projector is physically
2-1