Christie CP2000-M User Manual page 154

Appendix A: Serial API
Table A.1 Function Codes
EXAMPLES:
(PRM+C108 1) Use cinema processing mode on channel 108
(PRM+C108 0) Do not use cinema processing mode on channel 108
(PRM?) Get current processing mode
Power (PWR)
DESCRIPTION
Change the power state of the projector. Data can be:
3 - Power OFF - all electronics power off except Projector Control Module (PCM). It's also called standby mode
1 - Power ON projector is powered on with lamp) ON
0 - FULL POWER mode - projector is ready for lamp ON
11 - Warm up. Read only, it's middle status between STANDY and FULL POWER mode
10 - Cool down. Read only, projector will stay in COOLING DOWN mode for 15 minutes after lamp is turned OFF.
SUBCODE
None
STAT
EXAMPLES:
(PWR+STAT?) - Get projector power status 
(PWR3) - Set the projector to
(PWR0) - Turn the projector
(PWR1) - Turn the projector
(PWR?) - Get the last command sent to projector
Table A.2 Projector Power Modes
NOTES: 1) The green status LED flashes while the yellow LED is on steady while in "Boot Delay". 2) Both green and yellow status LEDs flash during "Cool
Down.
Remote Access Level (RAL)
DESCRIPTION
Set the remote serial protocol access level for a serial communications port. Note: Valid sections are 0 - No Access, 1 - Login
Required, 2 - Free Access.
SUBCODE
None
PRTA
A-18
DESCRIPTION OF USE
Select power state.
Read only status of current power state.
STANDBY
mode 
ON OFF

and lamp
ON ON

and lamp
DESCRIPTION OF USE
Set the access level on Ethernet all ports.
Set the access level on RS232 port A.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)