Table of Contents
Advertisement
9. The original factory boresight can be approximately recovered, by positioning the three
setscrews flush with the front face of the lens mount plate, and in contact with the inner lens
mount plate. This may require adjusting both setscrews and cap screws.
10. If further action is required. Repeat step 2.
11. Lock the setscrews, and re-check the boresight quality. Tighten the setscrew enough to ensure
they will not shift.
Powering down the projector
The projector can be powered down by using one of the following methods:
Remote keypad/built-in keypad
•
Press and hold Power.
or
•
Press Power twice.
or
•
Press Power once, then immediately press the Down key.
If the second key is not pressed immediately, a confirmation window appears. The second key
must be pressed within one second of the window appearing.
After powering down, the Status LEDs will cycle, and the LCD displays the message "Cooling Down"
until cool down is complete.
Web user interface (UI)
1. From the Main tab, select Power > OFF.
2. Select Yes.
M Series Quick Start Guide
020-101941-01 Rev. 1 (07-2015)
Installation and Setup
19
Advertisement
Table of Contents
