Network Function Test
Write Down Projector IP
1. Plug in power cord to the projector, connect PC and projector by LAN cable.
2. Turn on the projector.
3. On the Remote, select Menu > LAN.
4. Make sure DHCP is off.
5. Write down the following information:
•
The IP address: 10.0.21.200 (default).
•
The Subnet Mask: 255.255.255.0 (default).
Network Setting
1. On the PC, double-click the Local Area Connection.
2. Click Properties.
3. Select Internet Protocol (TCP/IP).
4. Click Properties.
5. Set the IP Address to 10.0.21.201.
6. Set the Subnet Mask to 255.255.255.0. NOTE: The Host ID (10.0.21.XXX) of the PC IP
Address must be different from the projector IP address.
7. Click OK.
8. Click Close.
Read Projector information
Internet Explorer version 8 or higher is required.
1. Connect the PC and the projector RJ45 Port by LAN cable.
2. Use Internet Explorer to navigate to http://10.0.21.200.
Captiva Service Manual
020-000867-03 Rev. 1 (05-2018)
Service Setup
10