Channel: Lamp Per Channel Menu - Christie CP2000-M User Manual

Section 3: Operation
The output delay setting shifts the 3D sync in relation to the Dark Time interval, starting each frame
slightly earlier (-) or later (+). Adjust only as necessary—too much offset can cause "bleed-through"
where each eye sees some data that is intended for the other, or causes color cropping since some
DMD sequences may be clipped.
• Phase Delay: Controls the degree of reference between the L/R sync output. Typically, a vertical adjustment
is required when using a Z-screen.

Channel: Lamp Per Channel Menu

This menu only becomes active if the channel is active. The Channel: Lamp Per Channel menu provides
controls for maintaining a specific light output over time (LiteLOC™), or setting a precise power level for the
lamp. A read-only area on the screen displays lamp performance details—the side bar graph represents the
current light output and, if LiteLOC™ is enabled, a heavy line shows the chosen LiteLOC™ setting.
A
Set and maintain consistent light output, as indi-
cated in the Set Light Level window (read-only)
B Lamp Power: Range adjustable from 50 - 100%
when LiteLOC™ is not in use
C Enable LiteLOC™ Function
D
Displays Current Channel
E Activate: Enabled when active channel selected
F Lamp Per Channel: Enable to keep lamp informa-
tion current for active channel
3-34
Figure 3-23 Channel: Lamp per Channel Menu
G
Change Icon: Press to change icon for current
channel
H Resets factory defaults
I Light: Reading from light sensor
J
Red bar indicates LiteLOC™ setting (desired
brightness)
K Lamp: Displays current lamp settings - automati-
cally updated (read-only)
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)