Optional) Mount The Control Display Panel - Christie CP2000-M User Manual

2.1.3 (Optional) Mount the Control Display Panel

The Control Display Panel (CDP) is shipped separately and must be connected and installed onto the rear door
using the existing mounting positions. For convenience, the display angle of the CDP can easily be modified
for improved viewing or it can be removed and permanently mounted in another location within the projection
room. NOTE: The CDP is not recommended for use as a handheld remote.
To modify the CDP display angle:
1. Place your hand under the bottom edge of the CDP and pull forward. Keep the back tab of the CDP fully
engaged to maintain the display angle (Figure 2-2/left).
To remove the CDP for installation in another location:
1. Grasp the CDP and slightly push it to one side. This creates a gap sufficient enough to release the CDP
from the top mounting pin on that side. Then release the other side and pull forward to remove (Figure 2-
2/right).
2. To install the CDP in another position, the mounting bracket must be removed from the rear panel (two
screws) and then reattached in the desired location (booth wall, etc.). Snap the CDP back into the holder
bracket. When installing the CDP in a new location ensure the distance between the projector and the CDP
is kept within 8 ft. (the max. length of the standard harness). NOTE: If more length is required, an optional
25ft. Harness kit (P/N: 108-283101-xx) is available.
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)
Figure 2-2 Control Display Panel
Section 2: Installation & Setup
2-3