Link Aggregation Commands - D-Link DGS-3224SR Command Line Interface Reference Manual

DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
L
INK
The link aggregation commands in the Command Line Interface
(CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create {group_id <value> {type [lacp | static]}
link_aggregation
delete group_id <value>
link_aggregation
config group_id <value> {master_port <port> |
link_aggregation ports <portlist> | state [enabled|disabled]
config [mac_source | mac_destination |
link_aggregation mac_source_dest | ip_source |
algorithm ip_destination | ip_source_dest
show {group_id <value> | algorithm}
link_aggregation
Config lacp_port <portlist> mode(1) [active(3) | passive(4)
Show lacp_port {<portlist>}
Each command is listed, in detail, in the following sections.
A
GGREGATION
C
OMMANDS
174
16