DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
above is then connected to the switch's serial port via an RS-232
DB-9 cable.
With the serial port properly connected to a management
computer, the following screen should be visible. If this screen
does not appear, try pressing Ctrl+r to refresh the console
screen.
Figure 1-1. Initial Console screen.
There is no initial username or password. Just press the Enter
key twice to display the CLI input cursor − DGS-3224SR:4#.
This is the command line where all commands are input.
Setting the Switch's IP Address
Each switch must be assigned its own IP Address, which is used
for communication with an SNMP network manager or other
TCP/IP application (for example BOOTP or TFTP). The switch's
default IP address is 10.90.90.90. You can change the default
6