Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
config ipif System
Purpose
Used to configure the System IP interface.
config ipif System [{vlan
Syntax
<vlan_name>|ipaddress
<network_address>|state
[enable|disable]} |bootp|dhcp]
Description
This command is used to configure the
System IP interface on the switch.
<vlan_name> − The name of the VLAN
Parameters
corresponding to the System IP interface.
<network_address>
netmask of th IP interface to be created.
You can specify the address and mask
information using the traditional format
(for example, 10.1.2.3/255.0.0.0 or in
CIDR format, 10.1.2.3/16).
state [enabled|disabled] − Allows you to
enable or disable the IP interface.
bootp − Allows the selection of the BOOTP
protocol for the assignment of an IP
address to the switch's System IP interface.
dhcp − Allows the selection of the DHCP
protocol for the assignment of an IP
address to the switch's System IP interface.
Restrictions
Only administrator-level users can issue
this command.
−
IP
address
186
and
Advertisement
Table of Contents
