Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
DGS-3224SR:4#
config 802.1p default_priority
Purpose
Used to configure the 802.1p default priority
settings on the switch. If an untagged
packet is received by the switch, the priority
configured with this command will be
written to the packet's priority field.
Syntax
config 802.1p default_priority
[<portlist>|all] <priority 0-7>
Description
This command allows you to specify default
priority
received by the switch. The priority value
entered with this command will be used to
determine which of the eight hardware
priority queues the packet is forwarded to.
Parameters
<portlist> − Specifies a range of ports that
will belong to the link aggregation group.
That is, a range of ports for which all
untagged packets received will be assigned
the priority specified below. The portlist is
specified
number and the beginning port number on
that switch, separated by a colon. Then the
highest switch number, and the highest port
number of the range (also separated by a
colon) are specified. The beginning and end
of the portlist range are separated by a
hyphen. For example, 1:3 would specify
switch number 1, port 3; 2:4 specifies
switch number 2, port 4. Thus, 1:3-2:4
specifies all of the ports between switch 1,
handling
of
untagged
by
listing
the
lowest
151
packets
switch
Advertisement
Table of Contents
