Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
config access_profile
and to enter specific values that will be
combined, using a logical AND operation,
with masks entered with the create
access_profile command, above.
Parameters
profile_id <value 1-8> −
add access_id <value 1-255> − Adds an
additional rule to the above specified
access profile. The value specifies the
relative priority of the additional rule. A
lower access ID, the higher the priority the
rule will be given.
ethernet − Specifies that the switch will
look only into the layer 2 part of each
packet.
vlan <vlan_name 32> − Specifies that the
access profile will apply to only to this
VLAN.
source_mac <macaddr> − Specifies that
the access profile will apply to only
packets with this source MAC address.
destination_mac <macaddr> − Specifies
that the access profile will apply to only
packets with this destination MAC
address.
802.1p <value 0-7> − Specifies that the
access profile will apply only to packets
with this 802.1p priority value.
ethernet_type <hex 0x0-0xffff> −
Specifies that the access profile will
apply only to packets with this
hexidecimal 802.1Q Ethernet type value
in the packet header.
238
Advertisement
Table of Contents
