Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
config port_security
Syntax
config port_security ports [ <portlist>| all ]
{admin_state
max_learning_addr
|lock_address_mode
[DeleteOnTimeout|DeleteOnReset]}
Description
This command allows for the configuration of the
port security feature. Only the ports listed in the
<portlist> are effected.
Parameters
<portlist>
configured. The portlist is specified by listing the
lowest switch number and the beginning port
number on that switch, separated by a colon. Then
the highest switch number, and the highest port
number of the range (also separated by a colon) are
specified. The beginning and end of the portlist
range are separated by a hyphen. For example, 1:3
would specify switch number 1, port 3; 2:4 specifies
switch number 2, port 4. Thus, 1:3-2:4 specifies all
of the ports between switch 1, port 3 and switch 2,
port 4, in numerical order.
all − configure port security for all ports on the
switch.
admin_state [enabled|disaled] – enable or disable
port security for the listed ports.
max_learning_addr <1-10> - use this to limit the
number of MAC addresses dynamically listed in the
FDB for the ports.
lock_address_mode[DeleteOnTimout|DeleteOnReset
] – delete FDB dynamic entries for the ports on
timeout of the FDB (see Forwarding Database
[enable
|
<max_lock_no
−
Specifies a range of ports to be
273
disable]
|
0-10>
Advertisement
Table of Contents
