Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
Command: config syslog host all severity all facility
local0
Success.
DGS-3224SR:4#
create syslog host
Purpose
Used to create a new syslog host.
Syntax
create syslog host <index 1-4> ] {severity
[informational | warning | all} | facility [
local0 | local1 |local2 | local3 | local4 |
local5 | local6 | local7 ] | udpport
<udp_port_number> | ipaddress <ipaddr>
| state [enable | disable]}
Description
This command creates a new syslog host.
Parameters
Host – host index or all hosts
Severity – three levels are supported:
Informational: informational messages
Warning: warning conditions
All: any condition
local0 to local7 – these are user-defined
facilities
udp_port – udp port number
ipaddr – IP address of the host
state – enables or disables reception of
event-notification messages
105
Advertisement
Table of Contents
