Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
DGS-3224SR:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID
: 1
Type
: LACP
Master Port : 1:10
Member Port : 1:5-1:10
Active Port :
Status
: Disabled
Flooding Port : X
DGS-3224SR:4#
config lacp_port
Purpose
Used to apply the Link Aggregation Control
Protocol (LACP) to a port or group of ports..
Syntax
Config lacp_port <portlist> mode(1)
[active(3) | passive(4)]
Description
This command will apply LACP to a port or
group of ports.
Parameters
<portlist> − The portlist is specified by
listing the lowest switch number and the
beginning port number on that switch,
separated by a colon. Then the highest
switch number, and the highest port
number of the range (also separated by a
colon) are specified. The beginning and end
of the portlist range are separated by a
181
Advertisement
Table of Contents
