Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
config link_aggregation
state [enable|disable]
Description
This command allows you to configure a
link aggregation group that was created
with the create link_aggregation command
above.
Parameters
<value> − Specifies the group id. The
switch allows up to 32 link aggregation
groups to be configured. The group number
identifies each of the groups.
<port> − Master port ID. Specifies which
port
aggregation group will be the master port.
All of the ports in a link aggregation group
will share the port configuration with the
master port.
<portlist> − The portlist is specified by
listing the lowest switch number and the
beginning port number on that switch,
separated by a colon. Then the highest
switch number, and the highest port
number of the range (also separated by a
colon) are specified. The beginning and end
of the portlist range are separated by a
hyphen. For example, 1:3 would specify
switch number 1, port 3; 2:4 specifies
switch number 2, port 4. Thus, 1:3-2:4
specifies all of the ports between switch 1,
port 3 and switch 2, port 4, in numerical
order.
state [enabled|disabled] − Allows you to
enable
(by
port
number)
of
or
disable
the
specified
177
the
link
link
Advertisement
Table of Contents
