Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
interfaces on the switch, the ports you assign to these VLANs
and IP interfaces will be removed from the System interface.
The IP address may be set using the Command Line Interface
(CLI) over the console serial port as follows:
1. Starting
at
the
3224SR:4# − enter the commands config ipif
System
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x's
represent the IP address to be assigned to the IP
interface named System and the y's represent the
corresponding subnet mask.
2. Alternaltively, you can enter DGS3224SR:4# − enter
the
commands
xxx.xxx.xxx.xxx/z. Where the x's represent the IP
address to be assigned to the IP interface named
System and the z represents the corresponding
number of subnets in CIDR notation.
The IP interface named System on the switch can be assigned
an IP address and subnet mask which can then be used to
connect a management station to the switch's Telnet or Web-
based management agent.
command
line
prompt
config
ipif
System
8
DGS-
ipaddress
ipaddress
Advertisement
Table of Contents
