Table of Contents
Advertisement
DGS-3224SR Stackable Gigabit Ethernet Switch User's Guide
show lacp_port
Control Protocol (LACP) status.
Syntax
show lacp_port {<portlist>}
Description
This command will show LACP status of a
port or group of ports
Parameters
<portlist> − The portlist is specified by
listing the lowest switch number and the
beginning port number on that switch,
separated by a colon. Then the highest
switch number, and the highest port
number of the range (also separated by a
colon) are specified. The beginning and end
of the portlist range are separated by a
hyphen. For example, 1:3 would specify
switch number 1, port 3; 2:4 specifies
switch number 2, port 4. Thus, 1:3-2:4
specifies all of the ports between switch 1,
port 3 and switch 2, port 4, in numerical
order.
Mode: either active or passive mode
Restrictions
None.
Example Usage:
To display LACP for port 1:5:
DGS-3224SR:4#show lacp_port 1:5
Command: show lacp_port 1:5
183
Advertisement
Table of Contents
