Mitsubishi Eclipse 1990 Service Manual page 673

1.4
steps
1. Throttle position sensor (with
in closed throttle position switch)
2. Idle air control motor
3. Gasket
4. Throttle body
Throttle position sensor
DISASSEMBLY SERVICE POINTS
POSITION SENSOR AND IDLE All?
CONTROL MOTOR REMOVAL
1. Do not disassemble the sensor and motor.
2. Do not immerse solvent to clean the sensor and motor.
Clean
then with shop towel.
1. Do not remove the throttle valve.
2. Check if the vacuum port or passage is clogged. Use
compressed air to clean the vacuum passage.
REASSEMBLY SERVICE POINT
THROTTLE POSITION SENSOR INSTALLATION
Install the throttle position sensor to the throttle body
as shown in the diagram.
REMOVAL