Mitsubishi Eclipse 1990 Service Manual page 644

Terminal 4
Terminal 2
9. When not using the scan tool, proceed as follows:
(1) Disconnect the throttle position
and connect the special tool.
tween the disconnected connectors.
(2) Connect a digital voltmeter
tion sensor terminal 2 (sensor output) and
4 (sensor ground.)
10. Turn the ignition switch ON (but do not start the engine).:
11. Check the throttle position sensor
value:
12. If there is a deviation from the' standard value, check
the throttle position sensor and the
13. Remove the feeler gauge.
14. Switch OFF the ignition switch.
--
connectors
set, be-
throttle
voltage.
__
.
,
. .