Mitsubishi Eclipse 1990 Service Manual page 290

11
ENGINE
sprocket
REMOVAL SERVICE
(1) Rotate the crankshaft
align the timing marks.
stroke top dead center position.)
Caution
The crankshaft must always be rotated in the
direction only.
(2) Tie the camshaft sprocket and timing belt with a cord
so that the position of the camshaft sprocket will not move
with respect to the timing belt.
(3)
with the timing belt attached.
Caution
After removing the camshaft sprocket, be sure
to rotate the crankshaft.
Camshaft
sprocket
Before removing the rocker arm
the special tools as shown in the
adjusters will not fall out.
INSTALLATION SERVICE
INSTALLATION
(1) Temporarily tighten the rocker shaft with the bolt so that
all rocker arms on the inlet valve 'bide do not push the
valves.
(2) Fit the rocker shaft spring from the
it so that it is right angles to the
TSB Revision
and Camshaft Oil 'Seat
SPROCKET
the special tool to remove the camshaft sprocket
ARM AND
REMOVAL
ARM AND SHAFT ASSEMBLY
,
(right) direction and
cylinder the compression
forward
,
ASSEMBLY
.
assembly, install
that the lash
,
and position
guide.