Mitsubishi Eclipse 1990 Service Manual page 251

ENGINE
Rear
Engine block
crankshaft seal
Engine
metal case
crankshaft seal
crankshaft seal
dust lip
PISTON, CONNECTING ROD
CYLINDER BLOCK
REMOVAL
(1) insert a
lip and the metal case of the
Angle the screwdriver through
case of the seal. Pry out seal.
Caution
Do not permit the
crankshaft seal surface. Contact of the screwdriver
blade
(2) Remove top ridge of cylinder bores with
reamer before removing pistons from cylinder block.
Be sure to keep tops of pistons covered during this opera-
tion. Mark piston with matching cylinder number.
(3) Ensure connecting rods and connecting rod caps match
and proper set for the cylinder number. Identify them
if necessary.
(4) Pistons and connecting rods must be removed from top
of cylinder block. Rotate crankshaft so that each connect-
ing rod is centered in cylinder bore.
(5) Remove connecting rod cap bolts. Push each piston
and rod assembly out of cylinder bore.
Be careful not to nick crankshaft journals.
(6) After removal, install bearing cap in the connecting
orientation on the mating connecting
TSB Revision
Piston,
and Cylinder
flat 'screwdriver between
the dust lip
crankshaft edge (chamfer) is permitted.
the dust
seal.
metal
blade contact
reliable ridge
a
rod.