Mitsubishi Eclipse 1990 Service Manual page 651

FUEL PUMP CONNECTOR"
(HOW TO REDUCE FUEL
When removing the fuel pipe, hose, etc.,
in the fuel pipe line is high, do the
as to release fuel pressure in the line and
running out.
Remove the rear seat cushion.
1.
(Refer to GROUP
2.
Remove the protector to disconnect the fuel
tor.
3. Start the engine and let it run until it stops naturally,
off the ignition switch.
4. Connect the fuel pump connector to install the
5. the rear seat cushion.
FUEL PUMP OPERATION CHECK'
1.
Check the operation of the fuel pump by
tool to force-drive the fuel pump.
2. If the fuel pump will not operate, check by using
following procedure.
circuit.
(1) Turn off the ignition switch.
(2) When the fuel,, pump
directly to the battery,
the fuel pump operation can be heard.
NOTE
As the fuel pump is an in-tank type, the fuel pump
sound is hard to hear, so remove the fuel tank
tube cap and check from the tank inlet.
(3) Check the fuel pressure by
with the fingertips.
Seat.)
normal, check the fuel pump drive
(black) is
if the sound of
the fuel hose
from
.
,