Mitsubishi Eclipse 1990 Service Manual page 714

ENGINE
Thermostat case assembly
or water pump
O-ring
Water inlet pipe assembly
Engine (Turbo)>
in.)
Projection
Water fitting or
water inlet fitting
Water Hose and Water
and
REMOVAL SERVICE POINT
After making mating marks on the radiator
clamp, disconnect the radiator
INSTALLATION SERVICE POINTS
Insert the O-ring to the water inlet pipe, and coat the outer
circumference of the O-ring with water or engine coolant.
Caution
Do not allow engine oil or other grease to adhere to the
O-ring.
Engine>
Squeeze out the sealant from the tube evenly and apply
it so that there is not too much
sealant.
Specified Sealant:
Mitsubishi Genuine Parts No.
RADIATOR LOWER HOSE/RADIATOR UPPER
HOSE CONNECTION
(1) Insert each hose as far as the projection of the water
outlet fitting or water inlet fitting.
(2) Align the mating marks on the radiator hose and hose
clamp, and then connect the radiator hose.
INSPECTION
WATER PIPE AND HOSE CHECK
Check the water pipe and hose for cracks, damage, clogs
and replace them if necessary.
TSB Revision
Engine>
RADIATOR
HOSE DISCONNECTION
O-RING INSTALLATION
THERMOSTAT CASE ASSEMBLY INSTALLATION
Engine (Turbo)
,
the hose
places without
or equivalent