Mitsubishi Eclipse 1990 Service Manual page 286

REMOVAL SERVICE POINTS
POWER STEERING PUMP REMOVAL
hose attached.
NOTE
Place the removed power steering pump in a place where
will not be a hindrance when removing and installing the
engine assembly, and tie it with a cord.
A/C COMPRESSOR REMOVAL
Disconnect the
compressor from the compressor bracket with the hose still
a t t a c h e d .
NOTE:
Place the removed A/C compressor in a place where it will
not be hindrance when removing and installing the engine
assembly, and tie it with a cord.
Do not bend the joint between
pipe force.
E N G I N E
REMOVAL
(1) Support the
(2) Remove the special tool which was attached when the
transaxle assembly
(3) Hold the engine
(4) Place a garage jack against the engine oil pan with a
piece of wood in, between, jack up the engine so that
the weight of
the engine mount bracket assembly, and then remove
the engine mount bracket assembly.
ENGINE ASSEMBLY REMOVAL
After checking that all cables, hoses and harness connectors,
etc., are disconnected from the engine, lift the chain block
slowly to remove the engine assembly upward from the engine
compartment.
TSB
power steering pump from the bracket with the
compressor connector and remove the
A S
a garage
removed.
with a chain block or similar
is no longer being applied to
hose and the A/C
S E Y
M B L
,
,