Mitsubishi Eclipse 1990 Service Manual page 355

ENGINE OVERHAUL
Crank pulley side
0
mm bolts
Oil pan viewed from lower side
(2) Secure the oil pump driven gear onto the left counterbal-
ance shaft by tightening the flange bolt to specified torque.
PLUG INSTALLATION
62
(1) Install a new O-ring to the
(2) Using the special tool,
fied torque.
OIL PAN INSTALLATION
(1) Clean both mating surfaces of oil pan and cylinder block.
(2) Apply a 4 mm
circumference of the oil pan flange.
Specified sealant:
MITSUBISHI GENUINE PART No.
equivalent
NOTE
(1) Be sure to install the oil pan quickly while the sealant
is wet (within 15 minutes).
(2) After installation, keep the sealed area away from
the oil and coolant for approx.
(3) Note the difference in bolt lengths at the location shown.
0
TSB Revision
Case,
Shaft and Can
plug and tighten to speci-
in.) wide bead of sealant to the entire
of front case.
or
hour.