Mitsubishi Eclipse 1990 Service Manual page 774

Engine (Non-turbo)>
Engine (Turbo) and
Accelerator cable
Link(A)
Engine (Non-turbo)>
.
cable
Engine (Turbo) and
Throttle cable
1. Remove the link protector. (Refer to
Check the slack in each of the inner cables in the
2.
accelerator cable, auto-cruise control cable and throttle
cable.
If the slack in an inner cable is excessive, or if there
is no play, loosen the adjusting bolts and the nuts in
the throttle lever and each link, to release the throttle
lever and each link. (The bolts and nuts should not be
removed.)
Link (A)
1. Adjust with the adjusting nut A so when the
the stopper, the accelerator cable play (inner cable play
reaches the standard value.
Standard value:
2. Fix the accelerator cable with the lock nut.
nut
THROTTLE CABLE
1. Adjust with the adjusting nut
the link A, the throttle cable play (inner cable play) reaches
the standard value.
Standard value:
2. Fix the throttle cable with the lock nut.
3. Tighten the throttle lever-side adjusting bolt to the specified
Engine>
torque.
Revision
Auto-cruise Control System
CABLE
O-l mm in.)
2-3 mm in.)
so when the lever
mm
hits
hits
in.)