Table of Contents
Advertisement
ENGINE OVERHAUL
TDC
here
the water pump sprocket, 'idler pulley,
and then around the tensioner pulley.
Install tensioner to block but do not tighten fasteners.
28 Nm (20
the tensioner up against the tensioner pulley
tighten fasteners to 31 Nm (22
pin can be removed and installed.
of the timing marks.
Install belt in
'this
the inspection cover on timing belt cover. With number
one cylinder at TDC, the timing marks on the camshaft
sprocket should be aligned together. If marks are not
aligned correctly, perform procedure again.
Revision
belt. Starting at the crankshaft, go around
crankshaft sprocket to
a torque wrench on the tensioner pulley, apply
of torque to tensioner.
torque being applied to the tensioner pulley move
tensioner plunger pin, Pretension is correct when
crankshaft 2 revolutions and check the alignment
front timing belt cover.
Timing Check; (timing belt cover installed), remove
Belt
up belt slack.
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
