Mitsubishi Eclipse 1990 Service Manual page 582

INSPECTION PROCEDURE 3
The check engine/malfunction indicator lamp
nate right after the
[Comment]
The ECM causes the check engine/malfunction indicator lamp to illuminate for five seconds
immediately after the ignition switch is turned to ON.
If the check engine/malfunction indicator lamp does not illuminate immediately after the ignition
switch is turned to ON, one of the malfunctions listed at right has probably occurred.
SCAN TOOL Date list
16 ECM power supply voltage (Refer to
OK
Measure at the ECM
Disconnect the connector, and measure at the harness
Check a burnt-out bulb.
OK
Measure at the combination meter connector
Disconnect the connector, and measure at the harness
side.
Voltage between and ground (Ignition switch: ON)
OK: Battery positive voltage
Check the following
OK
Check trouble symptom.
NG
Check the harness wire between combination meter and
ECM connector. Repair, if necessary.
( T U R B O )
ENGINE
AND ENGINE>
is turned to the, ON position.
TSB Revision
not
Defective
lamp circuit
Check the power supply ignitiori
(Refer to INSPECTION PROCEDURE 27.) ,
Check the con-
Check the check engine/malfunction
circuit. Repair, if
Repair
.
,
of E C M
system.,
lamp
,