Mitsubishi Eclipse 1990 Service Manual page 752

17-12
ENGINE AND EMISSION CONTROL
I Scan tool
[Comment]
Internal control module fault is detected.
the control
[Comment]
An open or shorted condition is detected in the speed control servo power relay control circuit.
Speed control servo check
(Refer to
Voltage between the terminal
Voltage between terminal
ground
OK: Battery positive voltage
Disconnect the connector and
measure at the harness side.
Voltage between terminal (4) and
around
Battery positive voltage
A u t o - c r u i s e c o n t r o l -
(Refer to
NG
0 2
control module
Replace
Check the following connector:
and
-- Check f o l l o w i n g c o n n e c t o r s :
and
OK
52 and 107
Revision
Auto-cruise Control
Malfunction of the PCM.
Malfunction of the speed control
Malfunction of the auto-cruise control relay.
Malfunction of the connector.
Malfunction of the
Malfunction of the PCM.
OK
NG
NG
servo.
Check trouble symptom.
NG
Replace the PCM.
Check trouble symptom.
necessary.
Check trouble symptom.
auto-cruise control relay and the speed