Mitsubishi Eclipse 1990 Service Manual page 221

ENGINE OVERHAUL
TSB Revision
Ignition
INSPECTION
SPARK PLUG CABLE
(1) must be between 3,000 to 12,000 ohms per
foot of cable. Replace any cable not within tolerance.
IGNITION COIL
(1) Measure the primary
connect an ohmmeter between the
corresponding to the
on the primary side of
ohm. Replace the coil if resistance is
(2) Remove ignition cables from
the coil. Measure the
between the towers of each individual coil.
resistance should be
coil if resistance is not within tolerance.
of each 'At the coil,
and the pin
in Resistance
0.51
towers of'
the coil
ohms. the
,