Mitsubishi Eclipse 1990 Service Manual page 233

ENGINE OVERHAUL
TSB Revision
EXHAUST MANIFOLD
REMOVAL
(1) Remove oil level gauge.
(2) Remove exhaust manifold. heat shield,
(3) Remove 8 exhaust manifold retaining
move exhaust manifold.
(1) Install new manifold gasket. DO NOT APPLY-SEALER.
(2) Set exhaust manifold in
and bolt, starting at center and
both directions to 23
procedure until all fasteners are
(3) Install exhaust manifold heat shield, ,
(4) Install oil level gauge.
CLEANING AND INSPECTION
(1) Discard gasket and clean all gasket surfaces of manifolds
and cylinder head.
(2) Test manifold gasket surfaces for flatness with straight
edge. Surface must be flat within 0.15 mm per 300 mm
in. per foot) of manifold length.
(3) Inspect manifolds for cracks or distortion. Replace man-
ifold if necessary.
Exhaust
Tighten
specified
and
nuts
in