ENGINE
CRANKSHAFT REAR OIL SEAL
REMOVAL AND INSTALLATION
and Post-installation Operatidn
Transaxle Assembly Removal and
Refer to GROUP
Refer to GROUP
Clutch Cover and Clutch Disc Removal and
Installation
Removal steps
1. Flywheel
2. Crankshaft rear oil seal
Transaxle Assembly.)
-Transaxle Assembly.)
INSTALLATION SERVICE POINT
CRANKSHAFT REAR OIL SEAL INSTALLATION
Caution
If burr or scratch is present on the crankshaft edge
(chamfer), cleanup with 400 grit sand paper to prevent
seal damage during
NOTE
When installing seal, no lube on seal is needed.
(1) Place special tool
pilot tool with a magnetic base.
(2) Position seal over pilot tool. Make sure
the words THIS SIDE OUT on seal. Pilot tool should
remain on crankshaft during installation of seal.
TSB Revision
Crankshaft Rear Oil Seal
of new seal.
on crankshaft. This is a
can read