Mitsubishi Eclipse 1990 Service Manual page 647

If not within the standard value range, turn the engine
speed adjusting screw to make the necessary adjustment.
NOTE
If the idling speed is higher
even when the engine speed adjusting screw'
closed, check whether or not there is any indication that
the fixed SAS has been moved. If there
that it 'has been moved,
are no indications that it has been moved, it
that there is leakage as a result
fast idle air valve (FIAV), and, if so, the throttle body
should be replaced.
7. Press the scan tool clear key, and release the
from the Actuator test' mode.
NOTE
Unless the motor is
will continue 27 minutes.
8. Switch the ignition switch.
9. Disconnect the scan tool.
10. Start the engine again and let it run at idle speed for
about 10 minutes; check to be
is normal.
standard value
fully
indication
the fixed SAS. If there;
possible
of the
motor
the Actuator test mode.
the condition
,
. .