Mitsubishi Eclipse 1990 Service Manual page 305

Timing marks
sprocket
mm
(2.36 in.)
or more
ENGINE
(1) Align the timing marks on the camshaft sprocket; crank-
shaft sprocket and oil pump sprocket.
(2) After aligning the timing mark on the oil pump sprocket,'
remove the cylinder block plug and insert a Phillips screw-
.
driver with a diameter of 8 mm
be sure that the screwdriver goes
or more. If the screwdriver will only go in 20
turn the sprocket once, realign the timing mark and check
that the screwdriver goes in 60 mm (2.36 in.) or more.
Do not take out the screwdriver until the timing 'belt is
installed.
(3) Install the timing belt so as not to be
the sprockets, by the following procedure.
Caution
If the timing belt is to
the mark indicates the clockwise direction.
Set the tension pulley so that the pin
(4)
bottom, press the tension pulley lightly against the timing
belt.
(5) Screw the tool into the engine left support
its end makes contact with the tensioner
point, screw the tool in
the set wire attached to the
(6) Remove the tool.
(7) Tighten the center bolt to the specified torque.
Specified torque: 48
TSB Revision
Timing Belt
BELT INSTALLATION
in,) before striking the counterbalance shaft,
(35
,
. . .
in.), and check
mm (2.36 in.)
25 mm
install that
are at the
until
At that
and then remove
tensioner.