Mitsubishi Eclipse 1990 Service Manual page 852

21
CLUTCH OVERHAUL
INSPECTION
CLUTCH COVER ASSEMBLY
Check the diaphragm spring end for wear and uneven
height.
Limit:
Check the pressure plate surface for wear, cracks and
seizure.
Check the strap plate rivets for looseness and replace
the clutch cover assembly if loose.
Rivet sink
CLUTCH DISC
Check the facing for loose rivets, uneven contact, deterio-
ration due to seizure, adhesion of oil or grease, and re-
place the clutch disc if defective.
Measure the rivet sink and replace the clutch disc if it
is out of specification.
Limit: 0.3 mm
Check for torsion spring play and damage and if defective,
replace the clutch disc.
Combine the clutch disc with the input shaft and check
sliding condition and play in the rotating direction. If it
does not slide smoothly or the play is excessive, check
after cleaning and reassembling. If the play is excessive,
replace the clutch disc and/or the input shaft.
TSB Revision
Clutch
Engine (Turbo) and
if wear is evident 'or height difference exceeds
limit.
mm in.)
in.)
21200110043
Engine>