Mitsubishi Eclipse 1990 Service Manual page 308

ENGINE
Counterbalance
TSB Revision
Timing Belt
TIMING BELT
Caution
If timing belt "B" is to be reused, use
it with an arrow on its flat side indicating the turning
direction (to the right).
INSTALLATION SERVICE POINTS
TIMING BELT
Install timing belt by the
(1) Ensure that crankshaft sprocket "B" timing mark and the
counterbalance shaft sprocket timing mark are aligned.
(2) Fit timing belt over crankshaft sprocket "B" and the
silent shaft sprocket. Ensure that there is no slack in
the belt.
BELT
Adjust the tension of timing belt
(1) Temporarily fix the timing belt
the center of the tensioner pulley is to the left and above
the center of the installation bolt, and temporarily attach
the tensioner pulley so that the flange is toward the front
of the engine.
(2) Holding the timing belt "B"
in the direction of the
belt so that the tension side of the belt is taut. Now tighten
the bolt to fix the tensioner.
Caution
When tightening the
pulley shaft does not rotate, with
it to rotate with the bolt can
on the belt.
(3) Press the belt at the shown point by
belt tension. If not,
S t a n d a r d v a l u e : 5 - 7 m m
REMOVAL,,
INSTALLATION
procedure.
TENSION ADJUSTMENT
by the following procedure.
tensioner such that
,
up with your
.
ensure that the
. ,
,
check