Mitsubishi Eclipse 1990 Service Manual page 263

ENGINE OVERHAUL
(6) Make certain oil holes in block line up with oil hole in
(7) Oil the bearings and, journals and install crankshaft.
(8) Apply 1.5 to 2.0 mm
(9) Install main bearing cap
TSB Revision
NOTE
All upper bearing in the crankcase have oil grooves.
All lower bearing shells installed in the (bedplate) main
bearing caps are plain. Crankshaft end play is controlled
by a flanged bearing on the number three main bearing
journal.
bearings and bearing tabs seat in the
Caution
Do get oil on
If may effect the sealer ability
to cylinder block.
19614 to cylinder block as shown
bearing shells.
Caution
Use only the specified
or damage
tab slots.
the
to in.) bead of Loctite
the figure.
together with lower'
"on
to