Mitsubishi Eclipse 1990 Service Manual page 147

ENGINE OVERHAUL
Phillips screwdriver
F r o n t
bearing
TSB Revision
Front Case,
REMOVAL SERVICE POINTS
PAN REMOVAL
(1) Remove all oil pan bolts.
(2) Drive in the special tool between the
oil pan.
NOTE
Never use a screwdriver or chisel, instead of
tool, as a deformed oil pan flange
PLUG REMOVAL
(1) If the plug is too tight, hit the plug head with a hammer
two to three times, and
FLANGE BOLT REMOVAL
(1) Remove the plug on the side of cylinder block.
(2) Insert a Phillips screwdriver [shank diameter 8 mm
in.)] into the plug hole to lock the counterbalance shaft.
(3) Loosen the flange bolt.
COUNTERBALANCE
REMOVAL
Using the special tool, remove the counterbalance shaft
front bearing from the cylinder block.
NOTE
Be sure to remove the front bearing
If it has not been removed, the Rear Bearing Puller cannot
be used.
and Pan
result in oil leakage.
the easily loosened.
plug will be
FRONT
and.
,