Mitsubishi Eclipse 1990 Service Manual page 152

ENGINE OVERHAUL
Crank pulley side
8 mm bolts
Oil pan viewed from lower side
Drain pi
gasket
(1) Clean both mating surfaces of
(2) Apply a 4 mm
circumference of the oil pan flange.
Specified sealant:
MITSUBISHI GENUINE
equivalent
NOTE
Be sure to install the oil pan quickly
is wet (within 15 minutes);
(2) After installation, keep the sealed area
the oil and coolant for approx.
(3) Note the difference in bolt lengths at the location
DRAIN PLUG GASKET INSTALLATION
Install the drain plug gasket in the direction shown in the
illustration.
OIL COOLER INSTALLATION
First insert the oil cooler projecting stopper in the oil filter
bracket groove and then tighten the oil cooler
TSB Revision
Front Case,
Shaft and. Pan
P A N
in.) wide bead of
.
and cylinder block.
to the entire
or
. .
the sealant'
from,,
hour.
.
,