Mitsubishi Eclipse 1990 Service Manual page 157

ENGINE OVERHAUL
Base
Piston pin
Front
Base
Stop
Lock nut
INSTALLATION SERVICE
(1) Thread the stop screw and lock nut
1
(2) Using the markings on the
(3) Place the base on press support blocks.
(4) Slide the piston pin over the threaded end of the press
pin, and thread the correct guide pin
(5) Coat the piston pin with oil, and
held in position, slide the guide
and connecting rod.
(6) Press the piston pin through'
guide pin contacts the stop screw.
(7) Remove the piston
the guide pin and press pin from the assembly.
Connecting rod
guide pin
it is necessary to visually check the piston pin depth
after installation to verify that the piston pin is cen-
tered. Adjust if
(8) Check that the piston moves smoothly.
TSB Revision
Piston and Connecting Rod
PIN INSTALLATION
base. Fit the correct piston support on top of the base,
the press pin, threaded end up, into
the piston support until the
screw.
screw to the depth as shown below.
Depth:
Refer to the operating instructions on the
Due to production tolerance variations,
into the
hole in
pin touches the stop
pin, stop
tool.
it.
connecting rod
through the piston'
until the
from the base. Remove