Mitsubishi Eclipse 1990 Service Manual page 2012

INSPECTION PROCEDURE
Code No. 14 Analog
[Comment]
The SRS-ECU monitors the analog
it detects a sensor failure, abnormal sensor characteristics or abnormal sensor output.
Insulating tape
Replace the SRS-ECU.
Code No. 15 or 16 Safing
These codes are output when the resistance value between the safing
terminals in the SW-ECU is out of the normal range.
Refer to the following table 1 for the trouble causes of each code No."
Table 1
Code No. Trouble Symptom
Safing sensor short-circuited
15
16 Safing sensor open-circuited
Insulating tape
Replace the SRS-ECU.
SRS Troubleshooting
FOR DIAGNOSTIC'
sensor system
sensor output and outputs this code when
Caution
Turn the ignition key to the "LOCK" position, disconnect
the negative battery cable and tape the terminal.
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. (Refer to
sensor system
Caution
I
Turn the ignition
the negative battery cable and tape the terminal.
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. (Refer to P.
Revision
TSB
Probable cause,
Malfunction of SRS-ECU
,
Probable
,
Malfunction of SRS-ECU
sensor
. .
the position, disconnect