CONVERTIBLE TOP ASSEMBLY
REMOVAL AND INSTALLATION
Pre-removal Operation
Completely open the convertible top.
18
View A
7
Removal steps
Quarter belt moulding
(Refer to
Quarter trim, lower
(Refer to GROUP
Rear speaker
(Refer to GROUP 54
1.
2. Clip
BODY
Electric Convertible Top
CONVERTIBLE TOP FIT ADJUSTMENT
(1) Remove the quarter trim, lower (Refer to
(2) Fully open
6
7
GROUP 51
Mouldings.)
Trims.)
Speaker.)
drive motor connector
Revision
TSB
Trims.)
close the top, then adjust the stopper
or
adjusting bolt so it contacts the flange as shown in the
illustration.
Post-installation Operation
Convertible top fit adjustment
3. Strip
4. Side attaching hook
5. Defogger connector
Rear
6.
7. Drain trough rear attaching clip
8. Convertible top assembly
GROUP
8
View A
5
(Refer to GROUP
strap