Mitsubishi Eclipse 1990 Service Manual page 2030

AIR BAG MODULES AND CLOCK SPRING
Caution
1. Never attempt to disassemble or repair the
air bag module or clock spring. If faulty,
replace it.
2. Do not drop the air bag module or clock
spring or allow contact with water, grease
or oil. Replace it if a dent, cracks,
deformation or rust are detected.
3. The air bag modules should be stored on
a flat surface and placed so that the pad
surface is facing upward.
REMOVAL AND INSTALLATION
bag module (Driver's side), Clock spring>
Operation
Set the steering wheel and the front wheels to
the straight ahead position, and then remove the
ignition key.
,
5
Clock spring removal
Post-installation inspection
1. Negative
2. Air bag module (Driver's side)
3. Steering wheel
4. Column cover lower
5. Clock spring and body wiring har-
ness
connection
6. Clock spring
Pre-installation inspection
SRS
Air Bag Modules and Clock Spring
4
steps
battery cable
TSB Revision
Do not place anything on top of
modules.
Do not expose the air
4.
temperature over
5. After deployment of an air bag, replace the
clock spring.
6. Wear gloves and safety goggles
handling an air bag that has
7. An undeployed air bag module should only
be disposed of in accordance with the
specified procedures. (Refer to
41
4
Air bag module (Driver's side)
removal steps
Post-installation inspection
1. Negative
tion
2. Air bag module (Driver's side)
Pre-installation inspection
52400240022
bag
module to
battery cable