Mitsubishi Eclipse 1990 Service Manual page 2039

SRS
Wires
Air bag module
Tires without wheels
battery
Air bag module
wire
wire
Air Bag Module Disposal Procedures
side>
1. Install nuts that are no longer needed to the four bolts
on the rear side of the air bag module, and tie on some
thick wire to secure to the wheel.
2. Take the SRS air bag adaptor harness
to the wires, pass it beneath the old tire and wheel assem-
bly, and connect it to the air bag module.
3. the air bag module into the wheel, and secure
it with wires that are tied to the bolt holes, the air bag
should face upward.
Caution
Leave some space below the wheel for the adaptor
harness. If there is no space, the reaction when the
air bag deploys could damage the adaptor harness.
4. Place three old tires, without wheels, on top of the tire
secured to the air bag module.
<Front passenger's side>
1. Connect the deployment wires to the SRS air bag adaptor
harness A, pass it beneath the tire and wheel
and connect it to the air bag module.
2. Pass the thick wires into the hole of the air bag module
bracket, and secure it to the wheel of the old tire with
wheel (4 locations), with the air bag facing upwards.
Caution
1.
Leave some space below the wheel for the deploy-
ment wires.
If there is no space, the reaction of the air bag
deployment could result in damage of the adaptor
harness.
2. While deployment takes place, do not have the
connector of the
A inserted between the tires.
3. Place three old tires, without wheels,
secured to the air bag module, and secure all tires with
ropes (4 locations).
that is connected
air bag adaptor harness
of the tire