Mitsubishi Eclipse 1990 Service Manual page 2037

<Front passenger's side>
Body wiring harness
Air bag
(red) connector
Insulation
side>
passenger's
SRS Air Baa Module Disposal
(5). Open the glove compartment.
(6) Disconnect the
Connection
(8) Connect the clock spring
air bag adapter harness A and pass the deployment wires
out of the vehicle.
(9) Connect the SRS air bag adapter harness A to the
connector (red) of the air bag module (front passengers
side) and pass the deployment wire out of the vehicle.
disconnect the two connected wires from each other, and
connect them to the two terminals of the battery (removed
from the vehicle) to deploy the air bag.
Caution
1.
TSB Revision
(red) connector of the air bag module
(front passenger's side) from the body wiring harness
connector.
NOTE
If the air bag module (front passenger's side) connector
is disconnected from the body wiring harness, both elec-
trodes of the air bag module (front passenger's side)
connector will be automatically shorted to prevent unin-
tended deployment of the air bag due to static electricity,
etc.
Connect two wires, each six meters (20 feet) long or
more, to the two leads of SRS AIR BAG ADAPTER HAR-
NESS A and cover the connections with insulation tape.
The other ends of the two wires should be connected
to each other (short-circuited), to prevent sudden unex-
pected deployment of the air bag.
a location as far away from the vehicle as
Before deploying the air bag in this manner,
check to sure that there is no one
the vehicle. Wear safety goggles,
protection.
connector (red) to SRS
near
ear