Mitsubishi Eclipse 1990 Service Manual page 1873

Items Adjustment procedures
1 Adjust by turning the two glass guide
T i l t
track adjusting bolts by equal amounts
adjustment
for both the front and rear side. (Refer to
2 Longitudinal Adjust by moving the equalizer arm
adjustment bracket up and down. (Refer to
Longitudinal Adjust by moving the glass guide rear
adjustment track forward or backward. (Refer to
NOTE
Glass
longitudinal adjustments should be carried -out at the same time.
Lii arm bracket
Measurement points
Cross section
A-A
a
37.0
(1.46) (1.22)
1.6
bracket
6. Push the up-stops firmly against the lift arm bracket of
the regulator, and then install the bolts. Dimensions a
and step 5. should be maintained at this time.
in
7. Tighten the mounting bolts and nuts of the front and
rear glass guide tracks.
Caution
Do not turn the adjusting bolts of the glass guide
tracks.
8. Install the mounting bolt of the equalizer arm bracket
for the regulator.
and mm (in.)
Gross
Cross
B-B
31.0
I I
I- I 1.9
.