Mitsubishi Eclipse 1990 Service Manual page 2033

Insulating tape
SRS
Air Bag Modules and Clock Spring,.
(6) Turn the ignition key to the "LOCK" position, disconnect
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the bat-
tery cable before doing any further work.
(Refer to
Align the mating marks of the clock spring, and, after turning
the front wheels to the straight-ahead position, install the
clock spring to the column switch.
Mating Marks Alignment
Turn the clock spring clockwise fully, and then turn back it
approx. 3
Caution
If the clock spring's mating marks are not
the steering wheel may not be completely
a turn, or the flat cable within the clock spring may be
severed, obstructing normal operation of the SRS.
(1) Before installing the steering wheel, be sure to first turn
the vehicle's front wheels to the straight-ahead position
and align the mating marks of the clock spring.
Caution
Be sure when installing the steering wheel, that the
harness of the clock spring does not become caught
or tangled.
(2) After installing, turn the steering wheel'
both directions to confirm that steering is normal.
INSTALLATION
Install the air bag module, taking care that the wiring is not
p i n c h e d .
CLOCK SPRING INSTALLATION
turns counterclockwise to align the mating marks.
STEERING WHEEL INSTALLATION
BAG MODULE (DRIVER'S SIDE)
aligned,
'the way in