Removing And Installing Speed Sensor On Front Axle; Assembly Overview - Speed Sensor On Rear Axle - Volkswagen Passat 2011 Workshop Manual

4.2 Removing and installing speed sensor
on front axle
Removing
– Raise vehicle.
– Separate connector -1- from speed sensor wire and from
speed sensor.
– Remove bolt -2- from wheel bearing housing.
– Pull ABS speed sensor out of wheel bearing housing.
Installing
– Before inserting speed sensor, clean hole inner surface and
coat speed sensor all-round with high-temperature paste
G 052 112 A3.
– Insert speed sensor into hole in wheel bearing housing and
tighten bolt to 8 Nm.
– Connect speed sensor to speed sensor wire.
4.3 Assembly overview - speed sensor on
rear axle
⇒ "4.3.1 Assembly overview - speed sensor on rear axle, front-
wheel drive", page 29
⇒ "4.3.2 Assembly overview - speed sensor on rear axle, all-wheel
drive", page 31
4.3.1 Assembly overview - speed sensor on rear axle, front-wheel drive
Passat 2011 ➤ , Passat Variant 2011 ➤
Brake systems - Edition 02.2014
29
4. Sensors