Container Create Volume - Adaptec AAR-21610SA Reference Manual

container create volume

To create a volume set from freespace, use the container
create volume command.
Notes
If you created a volume set you can run the list devices
command on the NetWare console to verify its creation and then
create the necessary NetWare disk partitions and volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create volume [/cache{=boolean}] [/
label{=string}] {scsi_device},{free_space}
[{scsi_device},{free_space}...]
Parameters
{scsi_device}
Specifies the ID for the SCSI device whose freespace you want
to use for creating the volume set. A SCSI ID consists of a
SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0
through 15 inclusive), and SCSI device logical unit number (0
through 7 inclusive). See the installation guide for your
controller to determine the number of buses it actually
supports.
For further details, see
Note that you must explicitly specify the entire ID for the
SCSI device (the SCSI channel number, device ID, and device
logical unit number).
{free_space}
Specifies the freespace used to create the volume set on the
specified SCSI device.
For further details, see
scsi_device on page
free_space on page
container Commands
1-10.
1-11.
3-32